Maintenance - Siemens SIMOTICS XP Operating Instructions Manual

Maintenance

Through careful and regular maintenance, inspections, and overhauls you can detect faults at
an early stage and resolve them. This means that you can avoid consequential damage.
Operating conditions and characteristics can vary widely. For this reason, only general
maintenance intervals can be specified here. Maintenance intervals should therefore be
scheduled to suit the local conditions (dirt, starting frequency, load, etc.).
Observe the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 11).
• Comply with the applicable national and sector-specific regulations.
• When using the machine within the European Union, comply with the specifications laid
down in EN 50110-1 regarding safe operation of electrical equipment.
Comply with the IEC / EN 6007917 standard or according to the appropriate country
regulations when carrying out all service and maintenance work on the machine.
When making changes or repairs to listed machines, maintain the corresponding design
standards! These machines are labeled on the rating plate with the following markings.
Note
Please contact the service center (Page 143), if you require support with service,
maintenance or repair.
1MB..5/6 shaft height 71 ... 355
Operating Instructions, 10/2021, A5E41926185A
UKCA marking
Great Britain (England, Wales and Scotland)
Customs union Eurasia
Eurasian customs union
Explosion-protected
China Compulsory Certification
9
103