Toshiba 42 UL21 Series Operating Instructions Manual page 25

Advanced Settings
Networked Standby
Mode
Note: For detailed information on the options of this menu refer to the Connectivity section.
Installation Menu Content
Automatic channel
scan (Retune)
Manual channel
scan
Network channel
scan
Analogue fine tune
Satellite Settings
Installation Settings
(optional)
Setup Home
Transponder (*)
Clear Service List
Select Active
Network
Signal Information
First time installation
Fransat Options(**)
Parental Control
System
Information
Reception
Information
CAS-Module
Upgrade
Change the IP and DNS configurations of your TV.
Enable or disable this feature by setting it as On or Off.
Displays automatic tuning options. D. Aerial: Searches and stores aerial DVB stations.
D. Cable: Searches and stores cable DVB stations. Analogue: Searches and stores
analogue stations. Satellite: Searches and stores satellite stations.
This feature can be used for direct broadcast entry.
Searches for the linked channels in the broadcast system. D. Aerial: Searches for aerial
network channels. D. Cable: Searches for cable network channels. Satellite: Searches
for satellite network channels.
You can use this setting for fine tuning analogue channels. This feature is not available
if no analogue channels are stored and if currently watched channel is not an analogue
channel.
Displays satellite settings. Satellite list: Displays available satellites. You can Add,
Delete satellites or Edit satellite settings on the list. Antenna installation: You can
change satellite antenna settings and/or start a satellite scan. Satellite Channel Table:
You can upload or download satellite channel table data using the related options.
Displays installation settings menu. Standby Mode Search (*): Your TV will search for
new or missing channels while in standby. Any new found broadcasts will be shown.
Dynamic Channel Update(*): If this option is set as Enabled, the changes on the
broadcasts such as frequency, channel name, subtitle language etc., will be applied
automatically while watching.
(*) Availability depends on model.
Using this menu, you can edit the main and backup home transponder parameters,
including the Pid of the related M7 operator, which are used to download the channel
list. Set your preferences and press the Green button to save the settings. Then start
an M7 operator installation using the Automatic channel scan>Satellite menu.
(*) This menu option will only be available if an M7 operator installation is performed.
Use this setting to clear channels stored. This setting is visible only when the Country
option is set to Denmark, Sweden, Norway or Finland.
This setting allows you to select only the broadcasts within the selected network to be
listed in the channel list. This feature is available only for the country option of Norway.
You can use this menu item to monitor signal related information such as signal level/
quality, network name, etc. for available frequencies.
Deletes all stored channels and settings, resets TV to factory settings.
Displays Fransat options.
Displays parental control options. Enter the PIN number you have defined in the initial
installation to view current settings.
Displays system information.
Displays current satellite reception information.
Displays current CAS module information.
Displays software upgrade options.
English - 24 - (**) Limited Models Only