Handlebar Switches - Yamaha TRACER MTT850 Owner's Manual

Handlebar switches

Left
2 1
3
4
5
1. Select switch " / "
2. Menu switch "MENU"
3. Dimmer/Pass switch " /
4. Turn signal switch " / "
5. Horn switch " "
Right
EAU1234M
1. Stop/Run/Start switch "
2. Drive mode switch "MODE"
3. Hazard switch "
/PASS"
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, press the
switch down to "PASS" while the
headlights are on low beam.
TIP
When the switch is set to low beam,
only the left headlight comes on.
When the switch is set to high beam,
both headlights come on.
Instrument and control functions
Turn signal switch "
To signal a right-hand turn, push this
1
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
2
3
Horn switch "
/ / "
Press this switch to sound the horn.
"
Stop/Run/Start switch "
EAU85531
/ /PASS"
To crank the engine with the starter,
" for the high
set this switch to "
" for the low beam.
the switch down towards " ". See
page 5-1 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
3-18
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU54212
/ / "
", and then push
" to stop the en-
3