SELECTING A MODE
Start the engine and shift the gear to neutral, 1st, or 2nd. Next, adjust
the engine speed so it is no greater than 3500 rpm.
NOTE: The S-HAC mode setting cannot be change (to mode-A or
mode-B) while a DTC (Diagnostic Trouble Code) is displayed.
Mode-A
The indicator light 1 will light for a lamp check (2 seconds) and
•
then become an engine run time indicator light. Note, however, that
even while the indicator light is lit to indicate the engine run time,
holding down the S-HAC switch 2 for more than 0.7 seconds will
cause the indicator light 1 to switch to slow flashing (mode-A).
To select mode-A, release the S-HAC switch 2 while the indicator
•
light 1 is flashing slowly (for about 1.8 seconds).
•
Selecting mode-A will cause the slow flash pattern to continue.
NOTE:
•
To switch to the normal mode from mode-A, hold down the S-HAC
switch until the indicator light 1 goes out.
•
To switch from mode-A to mode-B, first switch to the normal mode
and then switch to mode-B.
5-8