Ci18 - Curtis RU Series User Manual

CLEANING INSTRUCTIONS
Cleaning the Faucet and Sight Gauge - As Needed
The following cleaning process requires a mild solution of dish-washing
detergent and warm water, and One-Pro Beverage Equipment Cleaner
(Curtis PN WC-79001). Mix the One-Pro cleaner at a ratio of 1 oz. (28 g.)
per 5 gal. (19 L) of hot water (122°F/50°C min.).
1 Unscrew the handle/bonnet assembly and remove. Inspect the seat
cup for wear. Replace the seat cup if it is damaged.
2 Remove the hose on top of the gauge (if applicable) by pulling it
up and off of the cap. Remove the gauge cap and the glass tube.
Inspect the glass tube for cracks or chips.
WARNING - If the gauge glass is broken, carefully inspect and
remove all traces of glass and insert a new glass tube, then
thoroughly rinse out the faucet shank.
3 Wash - Wash the faucet and gauge parts in the detergent solution.
Clean the glass tube with a gauge brush soaked with the detergent
solution.
4 Rinse - Thoroughly rinse all parts with clean, warm water.
5 Sanitize - After rinsing, place the faucet and gauge parts in One-
15 minutes.
6 Air Dry - Remove the parts from the sanitizer, rinse thoroughly
and allow them to air dry.
7 Reassemble - When dry, reassemble the handle/bonnet. Hand
tighten the handle/bonnet onto the top of the faucet assembly.
Reassemble the gauge.
WASH
RINSE
SANITIZE
Handle
Bonnet
Seat cup
Faucet
Faucet Disassembly
Sight Glass Disassembly
* Hose used only on models with aeration feature

CI18

Hose*
Cap
Washer
Glass
Shield
varies
Washer
A