2.1
System Software Requirements
The G3X Touch must use the following or later FAA approved software versions for this AFMS revision to
be applicable:
G3X Touch System Software
This section is not intended to be a comprehensive list of approved software. It is
intended to provide a means to determine if this AFMS revision is applicable to the
software that is installed in the aircraft. Do not use this AFMS revision if the
has a software version less than that shown in the table above.
2.2
Standby Flight Instruments
Standby Instruments are required for aircraft approved for IFR operations.
Section 2.24, Kinds of Operations.
2.3
Navigation Systems for IFR Operations
Aircraft approved for IFR operations must use one of the following navigation systems
the G3X Touch
system,
Garmin
GNC 300XL / GPS 155XL
•
Garmin GPS, GNC, or
•
Garmin
GNS 480
•
Garmin
GTN 6XX / 7XX
•
Garmin
GPS 175 / GNX 375
•
Garmin
SL30
•
Garmin
GNC 255
•
Garmin
GNC 355/355A
•
OR
A separate, non-Garmin, IFR approved GPS and/or VHF navigation system along with a
•
dedicated Course Deviation Indicator (CDI) separate from G3X Touch.
Refer to the table in Section 2.24, Kinds of Operations.
Refer to the approved Airplane Flight Manual Supplement for the non-Garmin
navigation system (if installed) for information on IFR operations.
IFR operations are prohibited using G3X Touch while FPL Source is selected to Internal GPS
navigation as the navigation source on G3X Touch. When the internal navigation source is selected,
a cyan INT and magenta VFR annunciation is displayed on the HSI. When INT and VFR are
annunciated, IFR operations are prohibited based solely on guidance provided by G3X Touch.
190-01754-01 Rev. 5
FAA Approved
2 LIMITATIONS
Component
NOTE
and FPL Source on the PFD must be selected to External.
GNS 4XX(W) / 5XX(W)
NOTE
Software Version
9.0
AFMS or Supplemental AFM for the Garmin G3X Touch EFIS
installation
Refer to the table in
connected to
P a g e
| 2-1