Configuring The System - ADC H2TU-C-202 User Manual

Provisioning

Configuring the System

The Config menu, shown in
• Standard options
• ADC options (Figure 8 on page
• Date and time (see"Setting Date and Time" on page
• Master clear (see"Clearing the History, Alarm, and Event Log Screens" on page
• Reset to factory default configuration, described in
Monitor Performance
ID: xxxx--xxxx—-xxxx--xxxx
Most of the H2TU-C-202 configuration options can also be set from a network test center
through TL1 commands embedded in the ESF FDL (non-intrusive) or in the payload itself with
11-bit commands (intrusive).
To obtain additional information about remote provisioning commands, contact customer
service. See
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 15
that are supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an
extended set of options available only when using HiGain units exclusively. For a description of each option and
a list of option settings, refer to
To make changes to these options:
1 Press C to select the Config menu.
2 Use the ↑ and ↓
3 Use the arrow keys to select an option.
4 Press the SPACEBAR
5 Press ENTER to activate your choice.
14
Figure 6, allows you to make the following types of system configuration changes:
(Figure 7 on page 15)
15)
Event Log Config
+----------------------+
| Standard Options ->
| ADC Options
| Date and Time
| Master Clear
| Set Factory Defaults |
+----------------------+
05/15/2001 12:30:01
Figure 6. Config Menu
"Appendix D - Product Support" on page
show the Standard and ADC configuration options. Standard options are those
Table 5 on page 16
arrow keys to select Standard Options or ADC Options, then press
to cycle through the settings for that option.
October 25, 2002
12)
"Resetting to Factory Defaults" on page 24
Inventory Report
|
-> |
-> |
|
H2TU-C
68.
and Table 6 on page 17.
LTPH-UM-1072-03
25)
Rlogon Help
System: OK___
ENTER .
H2TU-C-202 List 2F