Table of Contents
Advertisement
4-2-2. Port Configuration
Function name:
Port Configuration
Function description:
Port Configuration is applied for the settings of the ports on the switch. By this
function, you can set or reset the values for Mode and Flow Control.
Parameter description:
Enable Jumbo Frames:
This function support jumbo frames of up to 9600 bytes, Just tick the
check box ( ) to enable it.
Default: disable
Link:
Show link status of this port.
Mode:
Set the speed and duplex of the port. If the media is 1Gbps fiber, there
are three modes to choose: Auto Speed, 1000 Full and Disable. If the
media is TP, the Speed/Duplex is comprised of the combination of speed
mode, 10/100/1000Mbps, and duplex mode, full duplex and half duplex.
The following table summarized the function the media supports.
Media type
1000M TP
1000M Fiber
In Auto Speed mode, no default value. In Forced mode, default value
depends on your setting.
Flow Control:
You can Just tick the check box ( ) to enable flow control. If flow control
is set Enable, both parties can send PAUSE frame to the transmitting
device(s) if the receiving port is too busy to handle. When it is set
Disable, there will be no flow control in the port. It drops the packet if too
much to handle.
Default: Disable
NWay
Speed
ON/OFF
10/100/1000M
ON/OFF
1000M
54
Duplex
Full for all, Half for 10/100
Full
Advertisement
Table of Contents
