M.2 Solid-State Drive And Heat Sink - Lenovo ThinkStation P340 Hardware Maintenance Manual

M.2 solid-state drive and heat sink

Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
The heat sink might be very hot. Before you open the computer cover, turn off the computer and wait several
minutes until the computer is cool.
Attention:
• To replace the Intel Optane memory, go to
• Do not attempt to replace the Intel Optane memory in the M.2 solid-state drive slot. Replacement of the
Intel Optane memory must be done by a Lenovo-authorized repair facility or technician.
• The internal storage drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data. When handling the internal storage drive, observe the following guidelines:
– Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed
for frequent changes or replacement.
– Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
– Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might
get damaged.
– Do not apply pressure to the internal storage drive.
– Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on a soft material, such as cloth, to absorb physical shocks.
Replacement procedure for M.2 solid-state drive and heat sink installed on the system board
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 53.
66
P340 Hardware Maintenance Manual
https://support.lenovo.com/docs/tg_ssd
.