Connections; Input; Output; Inserting/Exchanging Cards - Korg ToneWorks PXR4 Owner's Manual

Introduction

Connections

The diagrams below show some basic examples of how
the PXR4 can be connected. Refer to these diagrams, and
make connections as appropriate for your equipment.
Connections must be made with the power turned off.

Input

Set the [INPUT SELECT] switch to the input jack that you
want to use. ( p.8)
[MIC]
[GUITAR INPUT]

Output

[PHONE]
12
[LINE INPUT]
OUTPUT L/R
CD player, cassette deck, etc.
[OUTPUT]
Powered monitors, etc.
Headphones

Inserting/exchanging cards

SmartMedia (referred to in this manual as a "card") is
required in order to record on the PXR4.
Open the card slot cover, located on the side of the
1
PXR4.
The power must be off when you insert a card.
1
2
Insert the card.
2
Insert the card with its contacts facing downward.
Push the card all the way into the card slot until it
locks into place.
Be sure that the card is oriented correctly.
1 2
Notch
To remove the card, press it all the way to the back of the
slot to unlock it, and then pull out the card.
If you remove the card without unlocking it, the card may be
damaged.
Be sure to close the card slot cover during use.
3
3