Table of Contents
Advertisement
. . A A d d u u s s t t m m e e n n t t
.1 .1 M M e e a a s s u u r r in ing I
g Ins
nst t r r um
The measuring instruments, jigs, and tools required at the time of
The measuring instruments, jigs, and tools required at
are as specified below.
are as specified below.
a. A signal generator that can generate a
a. A
signal generator that can generate an output of signal timing produced by the adjusted (*).
this case, however, this signal generator should be capable of
this case, however, this signal generator should be capable of displaying all white and all black as a
screen display pattern.
screen display pattern.
* The word
* The word
" "
adjusted
adjusted
the signal generator, is maintained at 0.7Vp-p
the signal generator, is maintained at 0.7Vp-p
. . 2 2 o o e e r r s s u u
l l y y o o l l t t a a g g e e
INPUT: 100Vac ~ 240Vac
INPUT: 100Vac ~ 240Vac
. . 3 3
o o e e r r C C i i r r c c u u i i t t C C l l o o s s u u r r e e
1) Connect the suitable cable of the signal generator according to the setting mode.
1) Connect the suitable cable of the signal generator according to the setting mode.
2) Turn on the Power switch of the signal generator.
2) Turn on the Power switch of the signal generator.
3) Connect the AC power cable to the
3) Connect the AC power cable to the unit being adjusted.
4) Turn on the Power switch of the unit being adjusted.
4) Turn on the Power switch of the unit being adjusted.
5) After the completion of signal discrimination, the LED is turned blue.
5) After the completion of signal discrimination, the LED is turned blue.
.4 .4 A A D D C B
C Bia ias a
s and
nd Ga
Gain in A A d d u u s s t t
1) Enter an input signal of VESA 1024x768 @ 60Hz, in 32-gray gradation.
1) Enter an input signal of VESA 1024x768 @ 60Hz, in 32-gray gradation.
2) Enter the factory mode according to
2) Enter the factory
mode according to
3) Press the RIGHT or LEFT buttons several times to display the [AUTO CONTRAST] adjust menu.
3) Press the RIGHT or LEFT buttons several times to display the [AUTO CONTRAST] adjust menu.
4) Pressing the SELECT button, adjust the cursor to [AUTO COLOR]. When
4) Pressing the SELECT button, adjust the cursor to [AUTO COLOR]. When the SELECT button is
pressed, adjustment of the bias and the gain is carried out.
pressed, adjustment of the bias and the gain is carried out.
5) When adjustments have been finished, press the MENU/EXIT buttons several times to close the factory
5) When adjustments have been finished, press the MENU/EXIT buttons several times to close the factory
mode.
mode.
ume e n n t t s s , ,
i i gs
gs a a n n d T d T o o o o ls ls
" "
shall mean that the amplitude of each signal R, G, B, which is output from
shall mean that the amplitude of each signal R, G, B, which is output from
unit being adjusted.
" "
3.2 Enter Factory Mode
3.2 Enter Factory Mode
the time of the adjustment of the unit to be
the adjustment of the unit to be adjusted
n output of signal timing produced by the adjusted (*). In In
displaying all white and all black as a
± ±
0.05V when a load of 75ohm is connected.
0.05V when a load of 75ohm is connected.
" "
4- 4- 9 9
adjusted
the SELECT button is
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiSync 20WGX2 and is the answer not in the manual?
Questions and answers