Advertisement
Section 6. Operating Instructions
Switch power on at the fused spur.
The extractor has 5 push-buttons which illuminate when
selected
TL to switch on/off lights
T1 to switch on motor at the first speed
T2 second speed
T3 third speed
T4 fouth speed (intensive will remain on for 5 minutes)
To turn the motor off press T1
Auto Switch-Off
To activate the auto switch-off function, switch on the cooker hood at the desired speed
and immediately after press "T1" button for some seconds till all LED lights start Flashing.
Pressing one of the buttons (T1, T2, T3, T4) the auto switch-off can be programmed. Time
will be different according to the button which is pressed (T1=5 minutes, T2=10 minutes,
T3=15 minutes, T4=20 minutes). If the time of the switching-off is the same as the speed
previously set, the LED light Flashes. If the choice is different the LED of the speed
remains fixed.
IN CASE THE INTENSIVE IS CHOSEN, AFTER 5 MINUTES THE COOKER HOOD
AUTOMATICALLY PASSED TO 3^ SPEED AND THE AUTO SWITCH-OFF WILL BE AT THE 3^
SPEED.
Grease Filter Alarm
After 30 hours operating time of the cooker hood, at the moment of the switch-off, all the
LED lights will turn to fixed light for 30 seconds. This is to suggest the aluminium filters
require cleaning. To reset the alarm, press and hold T1+T4 buttons together. If this reset
operation is not carried-out, every time the cooker hood is switched-off the lights will
remain on for 30 seconds. This alarm will reoccur after each following 30 hours up to 120
hours operating time. At the end of the 120 hours operating time, at the moment of the
switch-off, all LED lights will start flashing for 30 seconds as a reminder that the aluminium
filter require cleaning or to rest the alarm. Once the alarm has been reset the procedure
starts again after 30 hours operating time of the cooker hood.
11
Advertisement
