Using The Transmitter; Switching The Transmitter On/Off; Monitoring The Audio Signal Via Headphones - Sennheiser SR 300 IEM Manual

Using the transmitter

To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established.
It is vital to observe the notes on frequency selection on page 19.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
If necessary, read the chapter "If a problem occurs ..." on page 21.

Switching the transmitter on/off

To switch the transmitter on:
Briefly press the
The transmitter switches on and the standard display appears.
To switch the transmitter to
If necessary, deactivate the lock mode (see page 16)
Keep the
The display panel then turns off.
When in the operating menu, pressing the
(ESC function) and return you to the standard display.
The STANDBY
To completely switch the transmitter off:
Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket.
The backlighting of the

Monitoring the audio signal via headphones

You can monitor the audio signal via the headphone output.
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
Set the headphone volume control
headphones on.
¶
.
STANDBY button
standby mode:
¶
STANDBY button pressed until "OFF" appears on the display panel.
STANDBY
¶
button is backlit in red both during operation and in standby mode.
¶
STANDBY button goes off.
·
to the minimum position before putting the
Using the transmitter
¶
button will cancel your entry
13