Hilti SIW 6 AT-A22 Original Operating Instructions page 10

4 Technical data
4.1 Impact wrench
Rated voltage
Weight in accordance with EPTA Procedure 01
including B22⁄8.0 battery
Rated speed under no load
Impact speed
Torque adjustment
Large standard bolts
Large high-strength bolts
Chuck
Storage temperature
Ambient temperature for operation
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value when tightening
screws/bolts and nuts of the maximum permitted
size (a )
h
Uncertainty for tightening screws/bolts and nuts
of the maximum permitted size
6 English
Setting I
Setting II
Setting III
)
)
WA
)
pA
)
pA
21.6 V
2.4 kg
0 /min ... 1,000 /min
0 /min ... 1,500 /min
0 /min ... 2,700 /min
≤ 3,500 bpm
Three settings (additional settings are possible
when using the intelligent torque module SI­AT­22
and the torque display shows "AT")
M8 to M16
M6 to M12
/ " square drive with ball-notch retention
1
2
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
105 dB(A)
3 dB(A)
94 dB(A)
3 dB(A)
9.2 m/s²
1.5 m/s²
2124663
*2124663*