Setting Flow Rate; Wired Remote - Elisa incite User Manual

Setting Flow Rate

FOR DUAL OUTLET (DIVERT) CONTROLLERS ONLY
Your Incite™ dual outlet controller has a High flow or Low flow function
available. Please note the factory default setting is Low flow on both outlets.
To change the outlet flow rate settings, follow the instructions below.
1. Ensuring the SmartValve is powered, but
without any outlets flowing, enable 'Setup'
mode by first turning the temperature dial to
full cold. Press and hold both buttons together
for 5 seconds.
The LEDs will flash twice quickly and
once slowly to indicate the controller
is in 'Setup' mode.
2. When in 'Setup' mode, both outlet 'Start/Stop'
button LEDs flash slowly to indicate flow is set
to LOW FLOW mode. Quickly flashing LEDs
indicate flow is set to HIGH FLOW mode.
3. Press the relevant 'Start/Stop' button to
change the outlet flow as required.
HIGH FLOW mode - quick flashing LEDs
LOW FLOW mode - slow flashing LEDs
4. To save the desired settings and to exit 'Setup'
mode, press and hold both 'Start/Stop' buttons
together for 5 seconds until both LEDs remain
on steady, without flashing. The LEDs will turn
off as soon as the 'Start/Stop' buttons are
released indicating all settings have been
saved and 'Setup' mode has been exited.
6

Wired Remote

SINGLE OUTLET
1. Press the 'Start/Stop' button on the remote to
turn the shower on.
2. The white LED display will flash until the
selected temperature has been reached.
When the LED display is constant, step into
your shower and enjoy!
3. Press the 'Start/Stop' button on the remote or
main controller to turn the shower off.
DUAL OUTLET (DIVERT)
1. Press the wired remote button to turn the
shower on.
2. Water will flow from the primary outlet as
determined during the 'Wired remote setup'
procedure. Refer to Wired Remote Installation
and User Guide.
3. If required, push and hold the button for 2
seconds to stop the 1st outlet and start the
2nd outlet.
4. The white LED display will flash until the selected
temperature has been reached.
5. When the LED display is constant, your shower
is ready to use.
6. Press the remote or active button on the
controller to turn the shower off.
7