Single Outlet Controller; Dual Outlet (Divert) Controller - Elisa incite User Manual

Single Outlet Controller

START/STOP
1. Turn the temperature dial to the required setting.
2. Press the 'Start/Stop' button on the controller to turn the shower on.
3. The white LED display will flash until the selected temperature has been
reached. When the LED display is constant, step into your shower and
enjoy!
4. The temperature may be adjusted whilst in the shower.
5. Press the '+' (boost) on the controller to increase the flow of the shower
when desired. To turn 'Boost' off, press the button again at any time.
Note: the strength of the boost will vary depending on the water system
pressure and the configuration of the pipework. For further information,
refer to the trouble shooting section and the Important Information
section in the Smart Shower Installation Guide.
6. Press the 'Start/Stop' button on the controller to turn the shower off.
As a safety feature, the SmartValve has a maximum run time of
20 minutes. The flow can be stopped and started at anytime by
pressing the 'Start/Stop' button.
This can be enhanced by activating and using the free
ShowerMe app. See pages 3 and 11 for details.
4
TEMPERATURE BOOST
Adjust before Increase flow rate during
or during shower shower

Dual Outlet (divert) Controller

START/STOP TEMPERATURE
Choose either outlet Adjust before
upon starting or during shower
1. Turn the temperature dial to the required setting. The temperature can be
adjusted at anytime by turning the dial.
2. Press the desired outlet button on the controller to turn the shower on.
3. The white LED display will flash until the selected temperature has been
reached.
Whilst the shower is in use, if the 2
the 1 outlet will automatically stop and the 2
st
Depending on system pipe runs, there may be a slight outlet
temperature change when switching between outlets.
4. When the LED display is constant, your shower is ready to use.
5. Press the active button to turn the shower off.
As a safety feature, the SmartValve has a maximum run
time of 20 minutes. The flow can be stopped and started at
anytime by pressing the 'Start/Stop' button.
This can be enhanced by activating and using the free
ShowerMe app.
See pages 3 and 11 for details.
CHANGE OUTLET
Outlet can be switched
whilst showering
outlet button is pressed,
nd
outlet will start.
nd
5