Table of Contents
Advertisement
3. Installation requirements
3.1
Mechanical requirements for the SF-10V display
Support structure
The support structure has to be provided and installed by the customer because they vary from system to system. Although, the
following must be taken into account and must be precisely calculated on individual basis:
1.
Weight tolerances : Ensure that the support structure and the floor on which or the wall against which the support structure
has to be installed, is able to handle the complete weight of the SF-10V display.
2.
Environmental conditions : Humidity, wind, temperatures, rain, salty etc.
3.
Location : Outdoor, altitude, etc.
4.
Ground stability
5.
Front clearances : For optimal impact ensure that there is sufficient free area in front of the SF-10V display and respect the
maximum viewing distance.
6.
Local regulations regarding such installations
W
ARNING
or the load holding capabilities. If there are doubts on a systems viability, consult Barco for advice on profes-
sional rigging organizations.
Individual basis
Support structures must be assessed on an individual basis. Never construct a wall if there is uncertainty regarding the stability of
an installation or the load holding capabilities. If there are doubts on a system's viability, consult Barco for advise on professional
rigging organizations.
Example of a support structure
The support structure below consists of vertical I beams which are provided with mounting plates. The mounting plates located in
the back of the support structure when mounting SF-10V tiles.
Image 3-1
The support structure in the above example is pure illustrative for a SF-10V display consisting of 12 tiles.
It's recommended to integrate a service platform in every other two row of the support structure . Such a
platform allows a fast and easy intervention, if required.
W
ARNING
the SF-10V display. For that sufficient free space should be available behind the display to ensure a good
ventilation. The higher the display the more free space is required.
12
:
Never construct a SF-10V display if there is uncertainty regarding the stability of an installation
:
90% energy is transferred into heat, which requires a certain amount of airflow at the rear of
R59770542 SF-10V DISPLAY 03/12/2010
Advertisement
Table of Contents
