RidgeLine 97006 Manual page 37

procedure:
Set the ignition switch (22) to lower position
Push the choke (21) fully back to OPEN position
spark plug (20) and dry it. Pull the recoil starter handle (26) for
several times to drain the fuel from the combustion chamber.
Wait until fuel vapours and refit the spark plug. Clean up any
spilled fuel and move the product at least 3 metres (10') away
before starting the engine to avoid any accidental fire. Wait the
engine to cool down and then start the product as described in
section "Cold start".
Stopping
1. Release the throttle interlock (2) / throttle trigger (3) and let the product run
at its idle speed for 10 – 15 seconds.
2. Set the ignition switch (22) to lower position
Fig. 24
WARNING! The cutting device (saw chain) will continue to run for
short time even after the engine has been switched off! Wait until
the cutting device has come to a complete stop before placing the
product on the ground!
NOTE: The product will become very warm after a long time using;
allow it to cool down completely before restart. If the product
cannot be switched on with warm start procedure, then refer to the
cold start procedure.
5. Basic operating / cutting procedure
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: Support@fot-usa.com
3
(STOP position) (Fig. 24).
37
(STOP position).
. Remove the
22