Table of Contents
Advertisement
10. Let the product run idle for about 30 seconds to warm it up.
NOTE: When pushing the choke back to OPEN position and the
engine speed gets inconsistent. Then pull the choke slightly out to
middle position to allow additional time for warming up. After warm
up push the choke back to OPEN position.
11. Hold the product with the left hand on front handle (5) and the right hand on
rear handle (1).
12. Press the throttle interlock (2) and then squeeze throttle trigger (3) (Fig. 22,
step 7). The saw chain runs.
21
Fig. 22
Warm start
1.
Push front hand guard (6) forward (Fig. 23, step 1). The saw chain is now
locked.
2.
Ensure the choke (21) is at the OPEN position
back to the OPEN position if necessary (Fig. 23, step 2).
3.
Set the ignition switch (22) to upper position (ON position) (Fig. 23, step 3).
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: Support@fot-usa.com
6
22
7
5
21
12
6
35
26
5
2
3
. Push the choke fully
Advertisement
Table of Contents
