Table of Contents
Advertisement
NOTE: Perform the following test before operating your product.
Start the product as described below and keep it in idle speed. The saw chain (7)
must not move when the engine is running idle.
WARNING! If the saw chain shows any signs of moving, stop the
engine immediately! Wait for all moving parts to stop! Contact an
authorised service centre or a similarly qualified person to re-
adjust idling speed!
4.
Starting/Stopping
WARNING! Make sure the cutting device is not touching the ground
or other objects when starting the product!
Ensure the rear handle (1) is in the upright position!
Cold start
1.
Push front hand guard (6) forward (Fig. 22, step 1). The saw chain is now
locked.
2.
Set the ignition switch (22) to upper position (ON position) (Fig. 22, step 2).
3.
Fully pull out the choke (21) to CLOSE position
4.
Hold the chain saw firmly on the ground with left hand on the front handle (5).
Your thumb and fingers shall grasp the handle.
5.
Place the right foot onto the rear hand safeguard (12) and step down.
6.
Pull the recoil starter handle (26) lightly until you feel resistance then pull it
rapidly (Fig. 22, step 4). Repeat until hearing a blasting sound (it usually
needs 4 – 6 pulls).
WARNING! Allow the rope to return slowly and in a controlled
manner after each pull! Do not pull out the recoil starter beyond the
red color band at the end of the recoil starter!
7.
Push the choke (21) fully back to OPEN position
8.
Pull the recoil starter handle (26) lightly until you feel resistance then repeat
until engine starts.
9.
Carefully pull the front hand guard (6) back toward the front handle (5) (Fig.
22, step 6).
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: Support@fot-usa.com
34
(Fig. 22, step 3).
(Fig. 22, step 5).
Advertisement
Table of Contents
