Front Lounge Seats - Roadtrek 210 Chevrolet Owner's Manual

FRONT LOUNGE SEATS:

To convert the lounge seat into a single bed:
1. Be sure all armrests are in an upright position. Swivel the captain's seat 270 degrees clockwise so that the
backrest is toward the center aisle, (see PictureB-P14).
2. Remove the lounge seat back and place the optional folding mattress hard side down between the
lounge seat base and captain seat base. Unfold the mattress and arrange to fit as necessary.
(See Pictures B-P16 and B-P17).
To convert back to a lounge seat, perform these steps in reverse order.
The lounge seat(s) is designed to carry a passenger while your vehicle is in motion, and is equipped with seat
belts installed for their protection. All passengers must be seated in the front captain's seats facing forward or the
passenger lounge seat with seat belts fastened while the vehicle is in motion. All other seats are not to be occupied
while the vehicle is in motion. The lap belts must be worn across the hips and not across the abdomen. Passengers
must sit well back in the seat and in an upright position.
Picture B-P14: Swiveled front captain seat.
Doc No: 21906532 Rev: 07
1
Copyright © Roadtrek Motorhomes Inc. 2010
Picture B-P16: As viewed through passenger front
door.
Picture B-P17: Front lounge bed.
DAILY LIVING
2
3
B - 6