Table of Contents
Advertisement
Item
Starting speed of JOG
operation
„ System parameters
Item
Electronic gear A1 to A4
Electronic gear B
Pulse input mode
Smooth drive
Excitation position at first
current ON
Automatic return operation
at current ON
Motor rotation direction
Note
When a system parameter has been changed, the new parameter will become effective after the power is cycled.
12.1 Setting
„ Resolution
The resolution can be set using the applicable driver switches or CS input.
• Using the switches
Use the resolution switches (SW1-No.3/No.4) to set a desired resolution per revolution of the motor output shaft.
OFF
OFF
Note
The new settings of the resolution switches will become effective after the power is cycled.
The values of resolution switches (SW1-No.3/No.4) can be changed with the system parameters for electronic gear
[SyS-0-00] to [SyS-0-04] as shown in the table below. Note that the calculated value must fall within the setting range
specified below:
Resolution setting range: 100 to 10000 P/R
Factory setting: 1000 P/R
SW1-No.3
SW1-No.4
OFF
ON
Note
• When a system parameter has been changed, the new parameter will become effective after the
power is cycled.
• If the calculated resolution exceeds the setting range, an electronic gear setting error warning
will generate. Check all of four combinations in the above table. Refer to page 56.
• If the power is cycled while an electronic gear setting error warning is present, an electronic gear
setting error alarm will generate. Refer to page 53.
Description
Set the starting speed of JOG operation.
Description
Set the denominator of electric gear.
Set the numerator of electric gear.
Select the pulse input mode.
Change the setting to enable/disable of the smooth
drive.
Select the position at which the motor is excited after
the power has been turned on.
When the motor was in a state of current ON, set
whether or not to automatically return the motor to the
position where it was stopped.
Select rotation direction of the motor.
ON
OFF
ON
OFF
Resolution 1000 P/R
OFF
ON
Resolution 10000 P/R Resolution 5000 P/R
Electronic gear B [SyS-0-04]
1000 ×
Electronic gear A1 [SyS-0-00]
Electronic gear B [SyS-0-04]
1000 ×
Electronic gear A3 [SyS-0-02]
ON
OFF
Resolution 500 P/R
ON
ON
OFF
Extended functions
OPX-2A screen display
[APP-7-02]
OPX-2A screen display
[SyS-0-00] to [SyS-0-03]
[SyS-0-04]
[SyS-1-00]
[SyS-1-01]
[SyS-1-02]
[SyS-1-03]
[SyS-1-04]
ON
Electronic gear B [SyS-0-04]
1000 ×
Electronic gear A2 [SyS-0-01]
Electronic gear B [SyS-0-04]
1000 ×
Electronic gear A4 [SyS-0-03]
Ref.
p.49
Ref.
p.43
p.44
p.51
p.46
p.46
p.47
−43−
Advertisement
Table of Contents
