Assigning Functions; Using The Programmed Buttons; Lock Function; Beep Function - Kenwood TS-870S Instruction Manual

11 OPERATOR CONVENIENCES

ASSIGNING FUNCTIONS

1 Press [MENU].
2 Turn the M.CH/VFO.CH control to select Menu
No. 45, 46, 47, or 48.
3 Press [UP], or [DOWN], or Mic [UP], or Mic [DWN]
to change the current selection for this Menu item.
Menu/
Function No.
No function assigned
OFF
00 ~ 68
CONFIGURATION"
69
70
71
72
73
4 Press [MENU] or [CLR] to exit from Menu mode.
• If the power is switched OFF before this step is
completed, the selection just made will be
canceled.

USING THE PROGRAMMED BUTTONS

Press one of the buttons labeled ENTER, TF-SET,
1MHz, or FINE.
• The assigned function activates.
After a Partial or Full Reset, the settings of the PF keys are
Note:
reset to default values.

LOCK FUNCTION

The Lock function disables some buttons to prevent you
from accidentally activating a function or disturbing
current settings.
Press [F.LOCK] to toggle the Lock function ON or OFF.
• "F.LOCK" lights when the Lock function is ON.
AGC AUTO
USB
64
Page
Function
Ref.
See "MENU
ENTER
TF-SET
1MHz
FINE
VOICE
F. LOCK
The following buttons and controls are NOT affected by
activating the Lock function:
Buttons NOT Locked
[ANT]
ATT˚[DOWN]
ATT˚[UP]
[AIP]
_
[AT˚TUNE]
[AUTO˚NOTCH]
25
[BEAT˚CANCEL]
22
[CLEAR]
43
[FULL/SEMI]
20
[METER]
21
[N.R.]
68
[ ] (POWER)
[RIT]
[SEND]
[TF-SET]
[THRU/AUTO]
[TX˚EQ.]
[VOICE]
(if assigned to a PF key)
[VOX]
[XIT]
Even after Lock has been activated, you can still use the
Note:
Tuning control with
when operating split frequency.

BEEP FUNCTION

The purpose of the Beep function is to provide an
audible signal that conveys information. There are two
types of signals:
• To confirm that a button has been pressed
• To report an error condition
The volume of the beep output can be selected via
Menu No. 38 (BP LV). If you prefer not to hear any
beeps, the function can be silenced via Menu No. 35
(BEEP). The following paragraphs explain more about
each type of signal.
Controls NOT Locked
AGC
CAR
DELAY
KEY˚SPEED
MIC
MONI
PROC
PWR
RIT/XIT
SQL
[TF-SET] to change your transmit frequency
AF
NB
RF