Quick Memory; Storing Into Quick Memory; Recalling From Quick Memory; Temporary Frequency Changes - Kenwood TS-870S Instruction Manual

QUICK MEMORY

Quick memory stores a maximum of five frequencies in
a stack arrangement. As each new frequency is stored,
all previously stored frequencies are bumped to their
next respective Quick memory channel.
When all five channels contain frequencies, storing one
more frequency then bumps all frequencies to the next
channel and the frequency in Quick memory channel 5
is bumped off the stack and erased. Due to the stack
configuration, it is not necessary to specify a memory
channel when you save a frequency to Quick memory.
➤
➤
24.911 14.235
Memory 1 Memory 2 Memory 3
➤
➤
21.200 24.911
Memory 1 Memory 2
➤
➤
10.103 21.200
Memory 1 Memory 2
Quick memory can only be programmed or accessed if
the VFOs are selected for transmitting and receiving.
That is, Conventional memory channels cannot be used
simultaneously with Quick memory channels.

STORING INTO QUICK MEMORY

Press QUICK MEMO [M.IN] while in VFO mode.
• Each time [M.IN] is pressed, the current VFO data is
written to Quick memory.
• Quick memory channels can store the same types of
data as Conventional memory channels 00 ~ 98.

RECALLING FROM QUICK MEMORY

1 Press QUICK MEMO [MR].
• The current Quick memory channel number
appears.
AGC AUTO
M.CH
CW
• If there is no data stored in any Quick memory
channels, then this step will not access Quick
memory.
➤ ➤
18.111 7.082 3.545
Memory 4
Memory 5
➤ ➤
14.235 18.111 7.082
Memory 4
Memory 3 Memory 5
➤ ➤
24.911 14.235 18.111
Memory 4
Memory 3 Memory 5
2 Turn the M.CH/VFO.CH control to select the Quick
memory channel (1 ~ 5) that you want.
AGC AUTO
M.CH
CW
3 To exit, press QUICK MEMO [MR].

TEMPORARY FREQUENCY CHANGES

1 Press QUICK MEMO [MR].
AGC AUTO
M.CH
CW
2 Turn the M.CH/VFO.CH control to select the Quick
memory channel (1 ~ 5) that you want.
AGC AUTO
M.CH
3 Turn the Tuning control to change the frequency.
AGC AUTO
M.CH
• You can change operating mode by pressing
[LSB/USB], or [CW/–R], or [FSK/–R], or
[FM/AM].
• It is possible to change the frequency then press
QUICK MEMO [M.IN] to store the new frequency
in the same Quick memory channel. This action
bumps the old frequency to the next higher Quick
memory channel in the stack, etc., but does not
affect the Quick memory channels that are lower
than the current channel.
4 To exit, press QUICK MEMO [MR].
Note: Quick memory channels can be tuned in this manner while
using the TF-SET function.

QUICK MEMORY \ VFO

The current Quick memory channel contents, including
the frequency data plus VFO "A" and/or "B" status, are
transferred to the VFO(s) by this function.
In Quick Memory Recall mode, press [M>VFO].
If a Quick memory channel is recalled, then you change the
Note:
recalled data, pressing
[M>VFO]
9 MEMORY FEATURES
FSK
FSK
transfers the new data to the VFO.
59