Error Messages; Command Use Precautions - Kenwood TS-870S Instruction Manual

Intelligent digital enhanced communications system
Hide thumbs Also See for TS-870S:
Table of Contents

Advertisement

● APPENDICES
Command
FB
Sets or reads VFO B frequency.
FD
Reads RX filter dot display.
Sets RX (VFO A/B, memory channel).
FR
FS
Fine function (OFF/ON)
FT
Sets TX (VFO A/B, memory channel).
FW
Sets or reads filter bandwidth. For SSB
and AM, sets or reads the high-pass filter
cut-off frequency.    
Sets or reads AGC time constant.
GT
Reads model number of the transceiver.
ID
Reads status of the transceiver.
IF
Sets or reads IF shift. For SSB and AM,
IS
sets or reads the low-pass filter cut-off
frequency.
Sets or reads keying speed while using
KS
the KY command.
KY
Converts input characters into Morse
code.
LK
Sets or reads Lock (OFF/ON).
DRS recording
LM
Sets or reads memory channels.
MC
Sets or reads modes.
MD
Sets or reads MIC gain.
MG
Sets or reads transmit monitor level.
ML
Sets or reads Transmit Monitor
MN
(OFF/ON).
MR
Reads memory.
MW
Writes into memory.
MX
Sets or reads AIP (OFF/ON).
NB
Sets or reads Noise Blanker (OFF/ON).
NL
Sets or reads Noise Blanker level.
NR
Sets or reads Noise Reduction (OFF/ON).
NT
Sets or reads Notch Filter.
PB
DRS playback.
PC
Sets or reads transmit power.
PL
Sets or reads Speech Processor level.
PR
Sets or reads Speech Processor
(OFF/ON).
PS
Sets or reads power (OFF/ON).
RA
Sets or reads RF ATT (attenuator).
RC
Clears RIT frequency.
RD
Lowers RIT frequency.
RG
Sets or reads RF gain.
86
Function
Command
Selects a meter function or reads
RM
meter values.
RT
Sets or reads RIT (OFF/ON).
RU
Raises RIT frequency.
RX
Selects receive mode.
SC
Sets or reads Scan (OFF/ON).
SD
Sets or reads Semi Break-in delay time.
SM
S-meter and TX RF meter readings
SQ
Sets or reads squelch level.
SR
Resets the transceiver.
TX
Selects transmit mode.
UP
MIC UP function
VD
Sets or reads VOX delay time.
VR
Triggers the Voice Synthesizer for
message output.
Sets VOX (OFF/ON).
VX
Sets or reads XIT (OFF/ON).
XT

ERROR MESSAGES

In addition to the Answer Command, the transceiver can
send the following error messages:
Error
Message
?;
Command syntax was incorrect.
Command was not executed due to
the current status of the transceiver
(even though the command syntax
was correct).
Note: Occasionally this message may not
appear due to microprocessor transients in the
transceiver.
E;
A communication error occurred such
as an overrun or framing error during a
serial data transmission.
O;
Receive data was sent but processing
was not completed.

COMMAND USE PRECAUTIONS

1 Do not use the control characters 00 to 1Fh since
they are either ignored or cause a "?" answer.
2 Program execution may be delayed while turning the
Tuning control rapidly.
3 Receive data is not processed if the frequency is
entered from the keypad.
Function
Reason for Error

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts-870

Table of Contents