Connecting Sub Woofer - Totem KIN PlayTower Owner's Manual

Audio Source Connections and Setup
Use the appropriate audio cable to then connect your other sources. Totem has supplied an
Optical and Mini jack cable to cover most requirements.
If you are connecting a turntable, use the RCA inputs of Aux 1. If your turntable is equipped
with a ground wire as well, connect it to the grounding post on the speaker. If the turntable
has a built in Phono Pre-Amp, set the switch located below the input to Line. If it
does not, set it to Phono.
ATTENTION: Be sure to use the right setting and consult your turntable's manual. Using the
wrong setting can damage your speakers and void the warranty.
Amp In / Connecting a Streamer
The AMP IN input bypasses the internal preamplifier so
features like volume and source select will not function.
This facilitates connecting and the functionality of
external streaming components. It is a 3.5mm jack so if
the streamer is not equipped with the same output, use
the proper adapter as required. Once connected, the
amp will be controlled by the connected device.

Connecting Sub woofer

A powered sub woofer can be easily added by connecting a single RCA
cable from the Sub Out on the KIN Play Tower to the Input on the sub
woofer. Or, add the Totem LINK wireless transmitter to add the KIN
SUB 10 or Tribe Solution Sub without the need for wires. Adding a
Totem sub woofer will substantially add to the bass capabilities of the
system.
Standby and AUTO on
When no audio input has been detected for 30 minutes, the KIN Play
Tower will go into Standby mode. It can automatically turn back on by
playing the last source that was used. KIN Play Tower can be "woken"
by pressing the standby button on the remote or the far left or right
sections of display.