Advertisement
Traction Motor
115 to 125 in lb
15
(13.0 to 14.1 N- -m)
16
18
15
16
19
RIGHT
FRONT
1. Socket head screw (6 used)
2. Flat washer (6 used)
3. Flange nut
4. Support bracket
5. Carriage screw
6. Transaxle mount plate
7. Rubber damper
Removal (Fig. 50)
1. Park vehicle on a level surface, turn on/off switch
OFF, set parking brake and remove key from switch.
2. Remove cargo box from vehicle (see Cargo Box Re-
moval in Service and Repairs section of Chapter 5 --
Chassis).
3. Open the battery circuit by carefully removing one of
the battery cables (see Opening Battery Circuit in the
General Information section of this chapter).
Electrical System
14
17
1
2
125 to 165 in- -lb
(14.2 to 18.6 N- -m)
8. Traction motor
9. Fan
10. Roll pin (2 used)
11. Washer
12. Socket head screw
13. Plastic cap (fits in rear frame)
3
4
5
Figure 50
NOTE: Label all electrical leads for assembly pur-
poses.
IMPORTANT: When removing wires from motor ter-
minals (A1, A2, F1 and F2), use a wrench to retain
lower nut while loosening upper nut (Fig. 52). If ter-
minal studs are allowed to turn during upper nut re-
moval, internal motor damage can occur.
Page 3 - - 34
6
7
5
8
9
14. Cable terminal boot
15. Hex nut
16. Lock washer
17. Positive battery cable
18. Cable terminal boot
19. Negative battery cable
Workman MDE
10
11
12
13
Advertisement
Chapters
Troubleshooting
