Setting Hot Water Temperature - Noritz WHiC56 Service Manual

Setting Hot Water Temperature

Operation
1
button is "ON".
2
Set the temperature using
the buttons inside
the cover .
Temperature Setting Options
When using °C mode:
37 38 39 40 41 42 43 44 45 46 47 48 50 55 60 65 70 75 80 85
Washing
Shower, hot water supply, etc.
dishes, etc.
If fi xtures incorporate mixing valves, set the temperature higher than usual.
* For applications that occasionally require a higher temperature setting, locate the remote controller in a convenient location.
* Consult local codes for minimum operating temperatures.
• Hot water temperatures shown are approximate and may differ from the actual temperature at the fixture
depending on external factors such as the season and length of piping in the system.
• When low temperatures are set (for washing dishes, etc.), if the incoming water temperature is already quite
high, it may be difficult to ensure the outgoing water temperature is as per the setting.
• Please check the temperature displayed before using any hot water.
Be especially careful using hot water after the set temperature has been changed.
• When the hot water temperature is adjusted using thermostat controlled water mixing valves, set the
temperature on the remote controller approximately 10°C higher than the required temperature to ensure the
appropriate fixture temperature.
Cover shown in
the open position.
(
°C :
The temperature settings below are examples. The temperature setting
necessary depends on the usage, the length of piping and the time of year.
* If
will be discharged at the temperature of
the storage tank.
Screen Display
(Ex.: 40°C)
(Ex.: 42°C)
High temperature
*Initial factory setting is 40°C
- 16 -
is displayed, hot water
Description
* The indicator is lit.
* The previously set hot water
supply temperature is shown.
)
< Display when high temp is set >
Blinks for approximately 10 seconds
(Ex.: 55°C)
Lit.