Version Display Mode; Dc Error Information Mode - Kenwood KDC-348U Service Manual

KDC-348U/4751SD/BT41U/BT648U
/U4549/U4549SD/U549BT/X395/X695

6. Version Display Mode

● How to enter the version display mode
While pressing and holding [RETURN] key, press [DISP] key.
● Default condition when the mode is started
Same as normal start-up.
● Mode structure
Version display mode can be executed independent of the current source.
However, this mode is supported only on the model that supports the fi rmware update function.
● Mode content
After entering this mode, system μ-com will display the following information regardless of the status.
Display content
1 0 1 1 W E
Display content
1 0 0 9 W M
1 0 1 0 W K
1 0 1 7 W E
1 0 1 7 W K
1 0 1 7 W M
1 0 1 8 W K
1 0 4 0 W K
1 0 4 3 W E
1 0 4 3 W M

7. DC Error Information Mode

● How to enter the DC error information mode
Press and hold [3] key and [6] key and reset.
● Default status immediately after the mode activation
It shall be same as normal activation.
● Mode structure
DC Error Info Mode is enabled regardless of current source.
● Mode content
Syscom shall display the following information after entering this mode. The operation shown below shall be workable.
Display content
D C E R R
D C O K
18
TEST MODE
Development name – Version (Micom)
– 2 0 0
KDC-U4549
– X . X X
KDC-X395
– X . X X
KDC-BT41U
– X . X X
KDC-BT648U
– X . X X
KDC-U549BT
– X . X X
KDC-X695
– X . X X
KDC-348U
– X . X X
KDC-4751SD
– X . X X
KDC-U4549SD
– X . X X
When DC error is detected (in case that one of capacitor leakage, wrong connection or
other detection is found)
When DC error is not detected (in case that none of capacitor leakage, wrong connec-
tion or other detection is not found)
Details
Model
C-1009WM
C-1010WKB
C-1017WE
C-1017WK
C-1017WM
C-1018W
C-1040W
C-1043WE
C-1043WM
Details
Development name