Leak Testing - Paderno vida 820-0083 User Manual

18

Leak Testing

GENERAL
Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas
leak test check must be performed at the installation site due to possible mishandling in shipment, or
excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks
following the procedures listed below. If the smell of gas is detected at anytime you should immediately
check the entire system for leaks.
BEFORE TESTING
Make sure that all packing material is removed from the grill including tie-down straps.
DO NOT SMOKE WHILE LEAK TESTING. NEVER PERFORM LEAK TEST WITH AN OPEN FLAME.
Make a soap solution of one part liquid detergent and one part water. You will need a spray bottle,
brush, or rag to apply the solution to the fittings. For the initial leak test, make sure the L.P. cylinder is at
least 80% full.
TO TEST
1. Make sure the control valves are in the off position, and turn on the gas supply.
2. Check all connections from the L.P. gas regulator and supply valve up to and including the
connection to the manifold pipe assembly (the pipe that goes to the burners). Soap bubbles will appear
where a leak is present.
3. If a leak is present, immediately turn off the gas supply and tighten the leaky fittings.
4. Turn the gas back on and recheck. Should the gas continue to leak from any of the fittings, turn off
the gas supply and contact customer service at 1-800-263-9768.
Only parts recommended by the manufacturer should be used on the grill. Substitution will void the
warranty. Do not use the grill until all connections have been checked and do not leak.
GAS FLOW CHECK
Each grill burner is tested and adjusted at the factory prior to shipment; however, variations in the local
gas supply may make it necessary to adjust the burners. The flames of the burners should be visually
checked.
Flames should be blue and stable with no yellow tips, excessive noise or lifting. If any of these
conditions exist, check to see if the air shutter or burner ports are blocked by dirt, debris, spider webs,
etc. If you have any questions regarding flame stability, please call customer service at 1-800-263-9768.
TM
ALWAYS CHECK FOR LEAKS AFTER EVERY L.P.
TANK CHANGE
Check all gas supply fittings for leaks before each
use. It is handy to keep a spray bottle of soapy
water near the shut-off valve of the gas supply
line. Spray all the fittings. Bubbles indicate leaks.