Adjustable Head - Elisa intuition User Manual

Adjustable Head

Vita™ Head
To avoid water dripping from the shower head
after use, we advise to tilt the head back to
allow residual water to drain out.
The above recommendation applies to both
adjustable and fixed shower heads.
Rotate the spray plate lever clockwise or
anticlockwise to select the desired spray pattern.
To select the preferred height for the shower
head, squeeze the side levers together to allow
the handset holder to move up or down the rail.
Angular adjustment is made by carefully but
firmly pulling forwards or pushing back the
shower head against the ratchet in the holder.
Removing the shower head: with the hose still
attached, disengage the pivot clip by pushing
in the outer grey button located on the front of
the shower head (near to the hose connection).
Remove the spigot from the bottom of the
handset by using the hose to pull clear. To
reattach: ensure the hose washer is in the
correct position, tighten the threaded spigot
into the hose using a suitable spanner, taking
care not to over-tighten. Reinsert the spigot into
the handset and engage the pivot clip prior to
placing the handset into the handset holder.
10
1. Inner
2. Middle
3. Outer
Fixed Head
The angle of the fixed shower head
can be adjusted. The shower head
is mounted on a multi directional
ball joint to allow for minor angular
adjustment in any direction by carefully
holding the shower head and moving
the head to the desired angle.
To avoid water dripping from the
shower head after use, we advise to
tilt the head to allow residual water to
drain out.
Note:. do not force the angle of the
head beyond its natural stopping point.
Bath Overflow Filler
1. Push the waste cover to engage the
plug fitting.
2. Push the waste cover again to
disengage the plug.
Do not leave the bath filler running
unattended. Although the overflow
will remove excess water once the
bath is overfilled, this may not be
sufficient to prevent the bath from
overflowing (depending on system
conditions).
11