Switching On And Off; Adjusting The Temperature - Elisa intuition User Manual

Switching On and Off

STARTING YOUR SHOWER
To activate the controller, use the proximity sensor, or touch the power
symbol until the screen wakes up, then push and release the lever to start
the shower. The Get Ready screen will appear on the display. After a
moment the target temperature will flash until it is reached. It will then
display the thermostatically controlled temperature.
39
Hello
Push Lever
ENDING YOUR SHOWER
Touch the power symbol for approximately 1 second, then push the lever
when prompted, to confirm and end the shower.
39
Push lever
to power o
The controller features a secondary method to turn the shower
off. This is done using the lever: joggle the lever down until the
flow is set to ECO, then joggle the lever down three more times in
succession.
As a safety feature, the SmartValve has a maximum run time of
20 minutes. The flow can be stopped and started at any time by
following the instruction on this page.
This can be enhanced by activating and using the free ShowerMe
app. See pages 3 and 16 for details.
6
39
Get
Ready
Warming
water turns on
Your
shower was Goodbye
9:20
water turns off

Adjusting the Temperature

From the Home screen you
can adjust the temperature
at any time, before or
during showering, by
turning the bezel.
TIP: This is your Home screen.
When in any of the Menu
or Settings screens, you
can easily return to the
home screen by turning the
temperature bezel.
TEMPERATURE FEEDBACK DISPLAY*
43
42
Warming
Turn clockwise to increase the
temperature. While the
temperature is adjusting the
screen will flash and the display
will show Warming. When the
desired temperature is reached,
the display will stop flashing.
* Very small changes in temperature may not result in Warming or Cooling
messages showing, only the temperature value will change.
34
35
Cooling
Turn anti-clockwise to decrease
the temperature. While the
temperature is adjusting the
screen will flash and the display
will show Cooling. When the
desired temperature is reached,
the display will stop flashing.
7