Error Codes - VALBERG FBI 14S42 C SAD929C Instructions For Use Manual

C C
Useful information Informations pratiques
Problems Possible causes
Incorrect loading.
The tableware was taken
out too early.
Tableware does not dry
The wrong program has
been selected.
Using cutlery with a low
quality coating.
48 48
Solutions
• Load the dishwasher as
described in this guide.
• Do not empty your
dishwasher immediately
after washing.
• Open the door to allow
steam to escape.
• Wait until the temperature
inside has decreased and
the tableware is not too hot
to touch before taking them
out.
• Start by unloading the
lower rack to avoid dripping
water onto clean tableware
from the upper rack.
• With a short program, the
wash temperature is lower,
which reduces the wash
performance. Choose a
program with a longer wash
time.
• Water drainage is more
difficult with these objects.
• This type of cutlery or
tableware should not be put
in the dishwasher.
FR EN
C C
Informations pratiques Useful information

Error codes

In the event of a malfunction, the dishwasher will display error codes to help you identify
the problem:
Codes Meaning
E1 Longer filling time.
The required temperature has
E3
not been reached.
E4 Overflow
The distribution valve is pointing
E8
in the wrong direction
Button held down for more than
E9
30 seconds.
Fault with the system that
Ec
controls the washing.
Loss of communication between
Ed the primary and display circuit
boards.
WARNING :
• In the event of an overflow, turn off the main water supply
before calling a technician.
• If there is water at the bottom of the tub due to an overflow
or small leak, this water must be removed before restarting
the dishwasher.
Possible causes
The taps are not open, the water
supply is blocked or the water
pressure is too low.
Heating element malfunction.
A dishwasher component is leaking.
Open circuit or defective distribution
valve.
Water or residue on the button.
Fault with the circuit board or motor.
Open circuit or broken
communication wiring.
49 49 EN FR