Advertisement
installing a threaded Accessory
1. The accessory MUST be:
• rated to at least 7,000 RPM
• 4-1/2" (115 mm) in diameter
• fitted with a threaded opening of 5/8"–11 UNC
• undamaged
• a grinding wheel suitable for surface grinding,
not edge grinding (accessories not included).
Battery Charging
Charge battery pack before using this tool. Follow instructions included
with battery charger. Battery Pack and Charger sold separately.
installing the Battery pack
note: Battery Pack sold separately.
1. With the Trigger Switch in the "OFF" position,
insert a fully charged battery pack into the
Battery Receptacle until it clicks in place.
2. to remove, push the latch on the
battery back and slide it out.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be hazardous objects, such
as utility lines or foreign objects, nearby
that will present a hazard while working.
Item 56401
For technical questions, please call 1-888-866-5797.
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and Inner
Flange and keep in a safe place.
4. Thread disc accessory onto the Spindle.
Wrench tighten onto the Spindle.
Battery
Receptacle
4. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
5. Before beginning work, provide for sparks
and debris that will fly off the work surface.
Battery pack
Latch
Page 11
Hide quick links:
Advertisement
