Table of Contents
Advertisement
Disconnecting a connected Wireless Network
•
Tap
setting of the connected device.
•
Tap
(FORGET) icon to disconnect.
Ethernet Lan (Gigabit)
Note:
To connect the I-Series 4 Slate to Ethernet, it will need an Elo I/O hub (E391994) or a POS stand (E392186/E482347). When available, the
I-Series 4 Slate will automatically prioritize the ethernet connection. If the I-Series 4 Slate does not, please follow the steps below.
•
Place the I-Series 4 into the Elo Home APK.
•
Set Wi-Fi to disable.
Go to Wi-Fi settings, tap Use Wi-Fi to disable
•
Tap Ethernet.
•
Tap toggle switch to enable
Airplane mode
This will disable all of the wireless transmission functions. Including cellular, Wi-Fi, and Bluetooth.
•
To enable
USB tethering
This feature is for sharing Internet connection to another device using a USB cable.
Note:
The USB cable must be connected first from I-Series 4 to another device or PC. If using the IO Hub plug in a USB type A cable
from your PC in any one of the four USB type A ports. If using the POS stand, plug in to one of the four USB ports in the neck of the
stand behind the Display. See Connected device → USB on this user manual.
•
Tap Hotspot and tethering.
•
Tap USB tethering, to enable
Bluetooth tethering
This feature is for sharing internet network connection to another device using Bluetooth.
Note:
The Bluetooth must be paired first from I-Series 4 to another device or PC. See Connected devices → Bluetooth on this user
manual.
•
Tap Hotspot and tethering.
•
To enable
Data Saver
User Manual –I-Series 4 Slate Value
.
, tap Airplane mode.
.
, tap Bluetooth tethering.
.
UM600644 Rev A page 29 of 81
Advertisement
Table of Contents
