Table of Contents
Advertisement
Available languages
Available languages
•
Use a special cleaner applicable for the surface
of the hob.
Stainless steel
•
For stainless steel edges of the hob use a
special cleaner applicable for the stainless steel.
•
The stainless steel edge of the plate can change
the colour as a result of high temperature.
•
Wash stainless steel parts with water, and then
dry them with a soft cloth.
•
To remove burn food, fat and stubborn stains,
let them soak for a few minutes in a small
amount of mild detergent before cleaning.
•
Use cleaning products designed specifically for
cleaning stainless steel in order to protect the
steel surfaces.
•
Do not use cleaning products containing
corrosive chemicals such as chlorides, do not
clean the surface with disinfectants, stain or rust
removers and immersion cleaners.
PAN SUPPORTS
The pan supports are not resistant to
washing in a dishwasher. They must
be washed by hand.
1. Remove the pan supports to easily clean the
hob.
Be very careful when you replace
the pan supports to prevent the
hob top from damage.
2. The enamel coating occasionally can have
rough edges, so be careful when you wash the
pan supports by hand and dry them. If
necessary, remove stubborn stains with a paste
cleaner.
3. After you clean the pan supports, make sure
that they are in correct positions.
4. For the burner to operate correctly, make sure
that the arms of the pan supports are aligned
with the centre of the burner.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
CLEANING THE HOB
•
Remove immediately: melted plastic, plastic
foil, sugar and food with sugar. If not, the dirt
can cause damage to the hob. Take care to
avoid burns.
•
Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny
metallic discoloration. Clean the hob with a
moist cloth and non-abrasive detergent. After
cleaning, wipe the hob dry with a soft cloth.
•
To clean the enamelled parts, cap and crown,
wash them with warm soapy water and dry them
carefully before you put them back on.
CLEANING THE SPARK PLUG
This feature is obtained through a ceramic ignition
candle with a metal electrode. Keep these
components well clean to prevent difficult lighting
and check that the burner crown holes are not
obstructed.
PERIODIC MAINTENANCE
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
9
Advertisement
Table of Contents
