Replacing The Bar Bolt - Jonsered CS 2240 Workshop Manual

Repair instructions

7.29 Replacing the bar bolt

Replacing the front bar guide.
1
Drain the oil tank.
2
Knock through the old guide bar bolt so that it falls
into the oil tank.
3
Remove the bolt from the oil tank.
4
Secure steel wire to the outer part of the bar bolt
(A), thread the steel wire through the oil tank and
out through the bolt hole in the crankcase (see
figure 70).
5
Pull the steel wire so the bolt comes out of its hole
(see figure 71).
6
Check that the bolt's square head fits in
the washer (D) which is positioned in the cut-out in
the crankcase.
7
Pull out the bar bolt with its nut. Place a spacer
between the nut and crankcase (see figure 71).
8
Refill with chain oil.
Replacing the rear bar guide
1
Pull out the bar guide (C) with the help of slip-joint
pliers (see figure 70).
2
Fit the bar guide with the help of a hammer.
52
– English
Fig 70
Fig 71