Burner Ignition and Gas Safety Device Part 6: Troubleshooting Part 7: Precaution Part 8: Specification This guide book explains everything you need to know about your new product. Please contact our Customer Care should you need further assistance through www.modena.com...
PART 1: SAFETY WARNINGS • If you do Not understand about the procedure installation of gas cooker, you should contact MODENA Service Center to perform the installation. • Prepare the support equipment required for installation like: • LPG gas cylinder.
PART 3: INSTALLATION Adjusting the Stove on Kitchen Table • Stove can be installed on the kitchen table as long as the table is resistant to heat. To make a hole at the kitchen table use cardboard templates to customize the size.
Page 7
10 cm. NOTE For the size of the hole a few other models that are Not contained In the above illustration can be seen in the table of specifications or can be consulted to MODENA Service Center...
MODENA technician, then it is not be the responsibility of MODENA. • Embed Seal Adhesive (glue) along the bottom edge of the stove. It is necessary to keep the moisture on the bottom of the stove.
• Install the Burner set on its position • Install the regulator on gas tube and stove is already use ATTENTION: • To avoid gas leakage, please use gas standard hose with gas safety device. • Use the hose and regulator are perfect to avoid gas leaks can cause explosions.
Lighting The Burner To ignite the flame easily, light the burner before placing the cooking utensil on the pan support. For the model with electric ignition switch united with the knob. To turn on the burner, push the knob and then turn to counterclockwise until the maximum fire symbol.
ATTENTION In the event of a gas leak, do not turn on electronic equipment, turn on the fan or testing by fire. Close the gas valve as soon as possible and open the whole window / vent. How to Use the Burner To use the burner properly, compare the burner diameter with cooking equipment diameter.
Other BH Series Control Knob The symbols on the control knobs mean the following: • No gas flow / OFF Maximum gas flow Minimum gas flow Automatic Ignition Lighting the Burner To acquire the flame easily, light the burner before placing the cooking utensil on the pan support.
For model without electric ignition: To light the burner without automatic ignition plug, or light the burner at the condition does n’t have electric power, turn on the fire using matches and approach the fire to the upper side of burner than push the knob and turn counter clockwise until the maximum fire symbol condition.
Page 14
Ignition Button In standby state, press the ignition button of the desired burner once to light up the flame. Plus Button When the fire had been lit up, press this key to increase the flame. Each press of the button increases one stage of flame. Minus Button Press this button to reduce the flame.
Page 15
Setting the Timer • When the burner has been lit, long press timer button to enter timer setting mode. The LED display will light up. • Press + and – button to adjust the time that shows up in the LED display. •...
Page 16
Burner Recommended Pot Diameter (cm) Small 12–14 Medium 14-20 Large 18-26 Double Ring 18-28 Triple Ring 18-28 NOTE Cooking equipment with a wide bottom surface will further accelerate the cooking process rather than a smaller surface. Diameter of cooking equipment does not exceed the maximum recommended size based on the above table.
PART 5: MAINTENANCE MODENA gas cooker are designed specifically for long-term use of time so it does not require complex treatment. However, there are some things that are encouraged to care for your gas cooker quality. Enameled Part Clean enameled layer with sponge and warm soap water. Do Not use the abrasive detergent.
• When you smell gas, immediately release the regulator from the gas tank, do not light a fire and immediately contact MODENA Service Center. • Frequently check the gas hose, to make sure that gas hose is far from hot surface, and Not in bent position.
Need help?
Do you have a question about the Dorato Series and is the answer not in the manual?
Questions and answers