SonicWALL NSA Series Getting Started Manual page 22

NSA_5000_4500_3500_GSG.book Page 21 Wednesday, January 19, 2011 6:21 PM
Connecting the LAN Port
1. Connect one end of the provided Ethernet cable to the
computer you are using to manage the
SonicWALL NSA Series.
2. Connect the other end of the cable to the X0 port on your
SonicWALL NSA Series.
The Link LED above the X0 (LAN) port will light up in green
or amber depending on the link throughput speed,
indicating an active connection:
- Amber indicates 1 Gbps
- Green indicates 100 Mbps
- Unlit while the right (activity) LED is illuminated
indicates 10 Mbps
Applying Power
1. Plug the power cord into an appropriate power outlet.
2. Turn on the power switch on the rear of the appliance next
to the power cords.
The Power LEDs on the front panel light up blue when you
plug in the SonicWALL NSA . The Alarm
and the Test LED will light up and may blink while the
appliance performs a series of diagnostic tests.
When the Power LEDs are lit and the Test LED is no longer lit,
the SonicWALL NSA is ready for configuration. This typically
occurs within a few minutes of applying power to the appliance.
Note:
LED may light up
If the Test or Alarm LEDs remain lit after the
SonicWALL NSA appliance has been booted, restart
the appliance by cycling power.
SonicWALL NSA 5000/4500/3500 Getting Started Guide Page 21