Advertisement
3. Remove the nuts from the cables.
4. Thread the cables through the rear discharge-chute
bracket
(Figure
7).
Note: Route the cable that is on the left side of the
handle assembly through the left side of the bracket;
route the other cable through the right side.
1. Discharge-chute brackets
5. Install 1 nut on each cable.
6. Thread the cables through the front bracket and install
the other nuts onto the cable
1. Nut
2. The cables are not loose.
7. Slide the ends of the cables into the slots in the pulley
(Figure
8).
8. Adjust the nuts on the cables so that the cables are not
loose between the bracket and pulley
9. Ensure that the chute door is parallel to the deck and
that the mower blade does not contact it when you
move the chute-control handle to the Closed position;
adjust the cables as necessary.
10. Use the cable ties to secure the cables to the fan guard
and away from moving parts
Figure 7
2. Pulley
(Figure
8).
Figure 8
3. Slots in pulley
(Figure
(Figure
9).
1. Cable tie
5
Installing the Trash Bag
Parts needed for this procedure:
1
Trash bag
Procedure
Install the trash bag into the slots in the handle assembly
(Figure
10).
8).
1. Trash bag
5
Figure 9
Engine not shown in callout bubble
Figure 10
2. Slots in handle assembly
Advertisement
