Operation - Dometic M65-700 Instruction And Operation Manual

Operation

6 .2 Installing the Thru-hull Fitting
1. Install the thru-hull fitting according to the manufacturer's
instructions.
I
The thru-hull fitting should be located well above the
water line and directly over the toilet.
2. Run a 5/8 in. (16 mm) I.D. marine sanitation quality hose
from the thru-hull vent fitting to the vent fitting on the
holding tank.
3. Secure the hose to the vent fittings with two stainless steel
band clamps at each connection.
6 .3 Installing the Dockside
Discharge Fitting
NOTICE: The holding tank on the toilet is designed to
withstand discharge by a properly operating discharge pump.
1. Install the dockside discharge fitting according to the
manufacturer's instructions.
I
The dockside discharge fitting should be located in
the deck directly above the toilet.
2. Run a 1.5 in. (38 mm) I.D. marine sanitation quality hose
from the dockside discharge fitting to the pumpout fitting.
3. Secure the hose to the fittings with two stainless steel band
clamps at each connection.
6 .4 Connecting the Water Supply
q
5 Removing the Pedal Cover
q Pedal Cover
w Back Plate
6
e
w
e Screws
1. Remove the two screws from the rear of the pedal
cover.
2. Pull off the pedal cover.
q
6 Water Supply Connections
q Water Supply Line
3. Attach the water supply line to the inlet fitting.
4. Turn on the water supply and flush several times to check
for leaks.
5. Replace the pedal cover.
6. Replace the back plate and secure with the screws.
7 Operation
NOTICE: Only flush water, bodily wastes, and rapid-
dissolving toilet tissue. Do not dispose of feminine hygiene
products or other non-dissolving items in the toilet.
This section describes how to operate the toilet.
Gravity-discharge Toilet
w
w Inlet Fitting
EN