Control Panel Components - Westinghouse iGen2500c User Manual

COMPONENTS

CONTROL PANEL COMPONENTS

3
2
1
10
11
12
1. USB Ports: Two-port 5V/2.1A USB outlet.
Accepts Type A USB plugs.
2. Parallel Operation Outlets: A compatible
Westinghouse
connected for additional power output.
3. Overload Reset: The generator inverter will
automatically switch OFF all AC output to protect
the generator if overloaded or if there is a short
circuit in a connected appliance.
4. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous
carbon monoxide gas. If increasing levels of CO
gas are detected, the CO Sensor automatically
shuts down the engine.
5. Ground Terminal: The ground terminal is used to
externally ground the generator.
6. Eco Mode: Eco mode minimizes fuel
consumption and noise by adjusting the engine
RPM to the minimum required for the current
load.
10 | Westinghouse Outdoor Power Equipment, LLC
Inverter Generator
5 6
4
9
7. Fuel Switch: Used to turn fuel knob to the run
(ON), choke, or OFF position.
8. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacle: Receptacle can supply a maximum
can be
of 20 Amps.
9. Data Center: Displays remaining run time (F),
power output in kW (P), fuel level in liters (L),
voltage output (V), and lifetime hours.
10. Low Oil LED: Indicates low oil level. When the
oil level in the crankcase falls below the safe
operating limit, the low oil level indicator will
illuminate and the generator will automatically
shut off the engine.
11. Overload LED: Indicates that the generator is
overloaded.
12. Output Ready LED: Illuminates when the
generator is operating normally. Indicates the
generator is producing electrical power at the
receptacles.
7 7
8