Table of Contents
Advertisement
REMOVE OEM DOOR AND PARTS
Cash Box
Screws (2)
14
Remove coin chute screws from existing cash box housing
and cabinet.
16
Remove all harnessing from controller and interface boards.
Save standoffs and hardware from both boards and set aside
for future installation of power supply board.
INSTALLATION GUIDE
Coin Chute
Controller Board
Pay Side of the
Cabinet
Interface Board
REVISION™ Door for National 157/167 - 158/168
15
Loosen 1/4" screws from top and bottom of panel and lift off.
NOTE:
It is recommended to retain all "P" shaped clamps
for future use to secure new wiring with new controller
assembly, and to maintain a cleaner application.
OEM Lock Bar
17
Then, using a Phillips or flat head screwdriver (depending on
machine), remove the (4) screws that hold (2) OEM lock bar
latches in place.
To TOC
Overview
13
R
R
Advertisement
Table of Contents
