NAUTICA AERO NTDR01 Instruction Manual page 11

How to Calibrate Your Drone
After turning your drone and the remote controller ON,
place the former to a flat surface. As shown in the image,
pull back the joysticks simultaneously towards the outer
corners.
After the sound beep, the LEDs of the drone will flash for
2 seconds, indicating that your Nautica Aero NTDR01
has been calibrated and is ready to takeoff.
Power
ON/OFF
HOW TO FLY NAUTICA AERO NTDR01
Flight With Remote Control
Make sure the drone and the remote controller are
both ON and connected and your drone is calibrated
as explained above. Also make sure you read all
instructions above for flight preparation and other
instructions in the "Safety and Maintenance" section of
this user manual.
Pay attention to the direction of your drone
before the flight. The front of the drone is
where the main camera is located, as shown in
the image.
When taking off, the rear should be faced towards you,
while the front should direct forward.
The optimum flight duration is 13-14 minutes.
The range of the remote controller is 164 ft /50 m
max. Bear in mind that the drone may not return
to home in the event that it exceeds this range.
11