Sharp VC-H992U Service Manual page 17

CHECKING THE VIDEO SEARCH REWIND
BACK TENSION
• Remove the cassette housing control assembly.
• After short-circuiting TP801 provided at the center
(facing to the main PWB), plug in the power cord.
• Checking
1. After pressing the play button, press the rewind button,
and set the video search rewind mode.
2. Place the torque gauge on the take-up reel disk, and turn
it counterclockwise very slowly (one rotation every 2 to
3 seconds) and check that the torque is within the set
value 3.4±1.5mN⋅m (35±15gf⋅cm).
Torque gauge
CCW
Figure 4-12.
Notes:
Set the torque gauge securely on the take-up reel disk.
If it is not secure, the measurement will be incorrect.
CHECKING THE PINCH ROLLER PRESSURE
• Remove the cassette housing control assembly.
• After short-circuiting TP801 provided at the center
(facing to the main PWB), plug in the power cord.
• Checking
Press the play button to set the playback mode.
1. Detach the pinch roller from the capstan shaft.
2. Engage the tension gauge adapter with the pinch roller
3. Gradually return the pinch roller, and measure the
Take-up reel disk
4. Make sure that the measured value is within setting 0.9
CHECKING AND ADJUSTMENT OF TENSION
POLE POSITION
• Remove the cassette housing control assembly.
• After short-circuiting TP801 provided at the center
• Setting
1. Turn off the power switch.
2. Open the cassette tape (T-120), and fix with tape.
3. Set the cassette tape in loading state.
4. Put the weight (500g) on the cassette tape.
5. Turn on the power switch.
6. Make the adjustment with the beginning of a T-120 tape.
• Checking
1. Set a cassette tape, push the REC button to place the
unite in the SP record mode. Now check the tension pole
position.
17
Pinch roller
Capstan shaft
Tension gauge adapter
Figure 4-13.
Do not separate excessively. Or the pinch lever and
pinch double action lever may disengage.
shaft, and pull in the arrow direction.
pulling force when the pinch roller contacts the capstan
shaft.
to 11.8 N (900 to 1,200g).
(facing to the main PWB), plug in the power cord.
500g
Weight to prevent
float (500g)
Figure 4-14.
VC-H992U
VC-H992U(A)
Tension gauge
900 - 1,200g
(T-120)