Sharp VC-H992U Service Manual page 28

Video cassette recorder
Hide thumbs Also See for VC-H992U:
Table of Contents

Advertisement

VC-H992U
VC-H992U(A)
INSTALLING THE MASTER CAM (AT REAR
SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as
shown below.
2. Place the master cam in the position as shown below.
Fully turn
clockwise
Fully turn counterclockwise
Face the wide tooth side ward
Note:
See the figure below for the phase matching between the
master cam and the casecon drive gear.
3. Finally fix with the E ring.
Casecon drive gear
Round mark
When installing the master cam,
align the casecon drive gear
round mark with the half-round
notch of master cam.
E ring
(XRESJ30-06000)
Master cam
Figure 4-44-1.
Master cam
Half-round notch
Figure 4-44-2.
REPLACEMENT OF LOADING MOTOR
• Removal
Apply grease
Figure 4-45.
• Replacement
Remove the loading motor, and install the replacement
loading motor as shown below.
Figure 4-46.
The loading motor pressing-in must be less than 14.7 N (15
gf).
Adjust the distance between motor and pulley to 10.2
+0.2
mm).
–0.2
28
Apply grease
No grease
+0.2
10.2
mm
–0.2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vc-h992ua

Table of Contents