Page 1
USER MANUAL Square 30 AC 120V 60Hz 1500W WARNING READ AND UNDERSTAND THIS ENTIRE OWNER’S MANUAL, INCLUDING ALL SAFETY INFORMATION, BEFORE PLUGGING IN OR USING THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN FIRE, ELECTRIC SHOCK, OR SERIOUS PERSONAL INJURY.
DO NOT use on soft surfaces, like a bed, bathrooms. where openings may become blocked. ͳ Risk of electric shock- DO NOT OPEN! ͳ DO NOT place clothing or other No user-serviceable parts inside. AMBE USER MANUAL - SQUARE 30...
Page 3
ͳ NEVER modify this fireplace. Doing ͳ This fireplace is tested and listed for so could result in personal injury or use only with the accessories listed in property damage. Modification of this this manual. Use of other accessories fireplace completely voids all warranties. not specifically tested for this appliance could void the warranty and/or result in ͳ...
Page 4
For support, inquiries and contact information visit www.ambefireplaces.com Postal Address: Escea North America LLC, 522 W RIVERSIDE AVE, STE N SPOKANE, WA, 99201-0580 UNITED STATES...
TABLE OF CONTENTS Important Safet Inf ormation Dimensions Preparation dware Installation an A d ssembly all avit Dim ensions Glass Fascia Installation Frameless Kit Installation Operation Car an d Maintenance Troubleshooting 630611_...
GL ASS FASCIA INSTALL ATION Remove the TWO screws as shown below and take off the black glass fascia with care. Use a screwdriver to take off the FOUR screws shown below. Remove the glass panel and move it to a clean, soft place to avoid scratching it. 630611_...
Page 10
Place the decorative crystals and driftwood log pieces on the designed slot and keep them even. After placing the decorative crystals and drift log pieces on the designed slot, fasten screws back on the glass panel and metal trim. Reinstall the fascia if desired. AMBE USER MANUAL - SQUARE 30...
FRAMELESS KIT INSTALL ATION Remove the TWO screws as shown in the below picture and take off the black glass fascia with care. Use a screwdriver to take off the FOUR screws shown below. Remove the glass panel and move it to a clean, soft place to avoid scratching it. 630611_...
Page 12
Take off the two brackets. Place the left, right, top, and bottom trims on the appliance and fix the part using the screws provided in the kit. AMBE USER MANUAL - SQUARE 30...
Page 13
Put the appliance into the wall opening and fix it with the screws provided. – – – – To finish, place the decorative crystals and driftwood log pieces on the designed slot and – keep them even. Install the glass and fit the wall lining up to the frameless trim. –...
Before operating, please review the IMPORTANT SAFETY INFORMATION on Pages 2 and – 3,and heed all warnings. Remote Control – – – – Touch Panel – Touch Panel – – – AMBE USER MANUAL - SQUARE 30 – – –...
Page 15
Touch Panel & Remote Control Operation BUTTON FUNCTION ACTION & INDICATION Turns the fireplace on/off. Power Controls flame brightness. Flame Settings: F5 - Brightest flame(default) F4 - Bright flame F3 - Medium flame F2 - Small flame F1 - Smallest flame Changes the color of the flame effect.
Page 16
Colour Settings: 1 - Orange (default) 6 - Purple 2 - Red 7 - Azure 3 - Blue 8 - White 4 - Yellow 9 - Violet 5 - Green 10 - Bright Pink AMBE USER MANUAL - SQUARE 30...
Page 17
NOTICE WHEN THE HEATER IS FIRST TURNED ON, A SLIGHT ODOR MAY BE PRESENT. THIS IS NORMAL AND SHOULD NOT OCCUR AGAIN UNLESS THE HEATER IS NOT USED FOR A LONG PERIOD OF TIME. NOTICE TO IMPROVE OPERATION, AIM THE REMOTE CONTROL AT THE FRONT OF THE FIREPLACE.
Plastic ͳ Wipe gently with a slightly damp cloth and a mild solution of dish soap and warm water. NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the ͳ surface. AMBE USER MANUAL - SQUARE 30...
Page 19
Maintenance RISK OF ELECTRIC SHOCK! DO NOT OPEN ANY PANELS! NO USER- SERVICEABLE PARTS INSIDE! ALWAYS TURN THE FIREPLACE OFF AND UNPLUG THE POWER CORD FROM THE OUTLET BEFORE CLEANING, PERFORMING MAINTENANCE, OR MOVING THIS FIREPLACE. FAILURE TO DO SO COULD RESULT IN ELECTRIC SHOCK, FIRE, OR PERSONAL INJURY.
1. Disconnect from power source and embers are not inspect wiring for loose connections and 2. Ember is in off mode. glowing repair or replace if necessary. 2. Ensure the ember button is pressed until on high. AMBE USER MANUAL - SQUARE 30...
Page 21
PROBLEM POSSIBLE CAUSE SOLUTION 5. Remote control 1. Low batteries. 1. Replace batteries in does not work remote control. 2. Not aiming control correctly. 2. Aim control at sensor located directly behind glass screen in center of unit just 3. Defective remote above logs.
Need help?
Do you have a question about the Square 30 and is the answer not in the manual?
Questions and answers