ATTACK 810 Series Operation Manual page 37

SECTION 6: STORAGE PROCEDURE
14B
Transmission No special attention needed
Drive axle No special attention needed
Tires The loader should be raised and axles
chocked to prevent tire contact with
ground.
Tire pressure should be reduced to
15PSI.
Lubrication Ensure that all points are lubricated
with specified grease oil.
Fluid levels All fluid levels should be checked and
topped up as necessary.
。
Wheel Wheel bearings should be repacked.
bearings
Battery Disconnect battery terminals
Note: 1. The environment weather storage scope of this machine:
2. Long-term storage may damage the seals within the hydraulic system
Page 37/57
810,820 Series wheel loader operation manual
FOR ONE MONTH
JST
Series
FOR INDEFINITE PERIOD
Drain transmission fluid.
Refill transmission.
Drain drive axle by removing drain
plug located on the underside of the
differential carrier housing. Reinstall
plug after draining.
The loader should be raised and axles
chocked to prevent tire contact with
the ground.
Tire pressure should be reduced to
15PSI, and sprayed with a rubber
preservative.
Ensure that all points are lubricated
with specified grease oil.
Release all fluid (oil)
Wheel bearings should be repacked.
The battery should be removed and
stored separately. The battery must be
stored in a cool dry place and must not
be exposed to direct sunlight. If the
battery is stored in the open, it must
be covered for protection against dirt
and moisture. A slow charge should
be given to the battery every one and
two months.
- - - - 30℃ ℃ ℃ ℃ - - - - 50 50 50 50℃ ℃ ℃ ℃
Updated 8/27/2013
Wheel loader