ATTACK 810 Series Operation Manual page 26

the far enough distance. A sudden halt could cause the load displacement.
- Do not impede the fire fighting equipment from use before parking or depositing the
equipment of loading.
- Report any mechanical or electrical irregularities immediately.
- Always be alert; Watch out for pedestrians and never drive too close to the vehicles in
front.
- Travel at a speed consistent with load and road conditions.
- Never operate the loader with any part of your body outside of the operator's
compartment.
- DO NOT leave the driver's cab with the loader running.
- ALWAYS properly shut down the loader before leaving the loader.
- ALWAYS park the loader on solid, level ground.
On severe slopes
- ALWAYS park the loader perpendicular to the steepest slope to prevent accidental
movement.
- Use proper flags, warning marks or barriers when parking in areas of traffic.
- Do not park your vehicle in the access points where obstruct the fire brigade.
- During parking, use the parking brake and put the key on the STOP position.
- If the tractor must leave with nobody watching it, remove the ignition key.
- Never park your vehicle on a slope.
- If it is necessary to park tractor on a slope (break down etc), use the wedge under the
wheels of loader.
WARNING: IF PROBLEMS OR EQUIPMENT MALFUNCTIONS OCCURRS WHILE
OPERATING THE LOADER, IT MUST BE PROPERLY TO SHUT DOWN AND CORRECT THE
CONTINUING TO USE MALFUNCTIONING EQUIPMENT CAN NOT ONLY BE UNSAFE FOR
THE OPERATOR AND OTHER PERSONNEL, BUT CAN LEAD TO FURTHER DAMAGE TO THE
WARNING: IN CASE OF AN ACCIDENT, REPORT TO YOUR SUPERIOR IMMEDIATELY.
NEVER NEGLECT AN INJURY EVEN IF IT APPEARS INSIGNIFICANT, GO IMMEDIATELY TO
THE DOCTOR, WHICH COULD AVOID COMPLICATIONS.
Page 26/57
810,820 Series wheel loader operation manual
PROBLEM.
LOADER AS WELL.
JST
Series
Updated 8/27/2013
Wheel loader