B.operator's Responsibility - ATTACK 810 Series Operation Manual

Wheel loader
Table of Contents

Advertisement

B.OPERATOR RESPONSIBILITIES
This chapter must be read and thoroughly understood prior to operating or performing any
maintenance on this equipment.
WARNING: FAILURE TO COMPLY WITH THE FOLLOWING SAFETY
PRECAUTIONS CAN RESULT IN SERIOUS INJURY OR DEATH AS WELL AS
EQUIPMENT DAMAGE.
Always follow the global safety rules applicable in your field.
Before using this loader, always check for proper operation and condition of the lights,
brakes, steering, transmission shifter, park brake and tires.
Do not operate a loader with defective features; refer to the maintenance section of the
Operation and Service Manual.
Always wear suitable footwear when operating this equipment and avoid loose fitting
clothing that might get caught in moving parts.
Before starting this loader, should wear seat belts, and confirm the lock had been fastened.
Always bring the unit to a complete stop, place the transmission in neutral, and set the
park brake before quit the unit.
Always bring the unit to a complete stop before shifting from forward to reverse or from
reverse to forward.
Always check the path clear prior to backing.
When loading the speed should be reduced to 5KM / H
Lift the bucket up to the transport position (about 20cm from the ground )
In crowded areas and when close to the Blind corners and a row of car ,be more careful.
be vigilant to other equipment and personnel .
Do not operate when the speed does not meet the operational conditions. Always limit a
good speed in order to ensure sufficient time for emergency braking.
Do not allow to use loaders to transport hazardous materials.
Do not allow to carry person by this loader.
The loader does not allow to drive on the soft road if do not know very clearly about the
road condition.
Before operating this loader, the roll cage must be raised, and make sure the pin in the
locking position.
In addition to the dragging outside hook, any form of traction is not allowed in loaders.
Do not remove the radiator cap when the engine is hot, otherwise, can cause severe
burns. Allow to remove the radiator cap after cooling.
Do not try to touch the just being run or down engine exhaust pipe and muffler, otherwise
it will cause serious burns.
After open the engine back cover, do not try to start the engine, if must start, take care
the hurt from the fan to hand.
Never refuel the unit while the engine is running.
When injecting the fuel, it can stop when the refueling gun automatic cut off, don't inject
too much. When refueling, no smoking, don't storage or use the fuel at fire place.
do not fill the fuel cell above the bottom of the filler screen. Do not overfill. Clean off any
spilled oil or fuel. Do not smoke while refueling. Do not store, spill or use fuel near an open flame.
Do not check the engine oil while the engine is running.
Do not use the battery in this unit to start other vehicles.
Before starting this loader, should wear seat belts, and confirm the lock had been
fastened.
Page 13/57
810,820 Series wheel loader operation manual
JST
Series
Updated 8/27/2013
Wheel loader

Advertisement

Table of Contents
loading

This manual is also suitable for:

820 series

Table of Contents